Low Beam Headlamps

The headlamps may be turned ON in 3 different ways:

• When the headlamp switch is placed in the ON position, for normal operation
• When the headlamp switch is placed in the AUTO position, for automatic lamp control
• When the headlamp switch is placed in the AUTO position, with the windshield wipers ON in daylight conditions, after a 6 s delay

The BCM will also command the low beam headlamps ON during daylight conditions when the following conditions are met:

• Headlamp switch in the AUTO position
• Windshield wipers ON
• Vehicle in any gear but PARK

When the BCM commands the low beam headlamps ON, the operator will notice the interior backlighting for the instrument cluster and the various other switches dim to the level of brightness selected by the instrument panel dimmer switch.