LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Engine Controls And Fuel - 5.3L (L83) Or 6.2L (L86) - DTC P0443 To DTC P3452 And Diagnostic Information And Procedures) >> Diagnostic Information And Procedures >> DTC P10E1, P10E2, P10E3, P10E4: Ignition On/Start Circuit Source Bypass Relay Control Circuit >> Typical Scan Tool Data

Typical Scan Tool Data

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
Ignition On/Start Circuit Source Bypass Relay Control Circuit High Voltage Test Status

Circuit Short to Ground Open Short to Voltage
Operating Conditions:  Ignition=On & KR171 Engine Control Module Wake-Up Relay=On
Parameter Normal Range:  OKorNot Run
B+ - Relay Coil OKorNot Run OKorNot Run OKorNot Run
Control - Relay Coil OKorNot Run OKorNot Run Malfunction
Ignition On/Start Circuit Source Bypass Relay Control Circuit Low Voltage Test Status

Circuit Short to Ground Open Short to Voltage
Operating Conditions:  Ignition=On
Parameter Normal Range:  OKorNot Run
B+ - Relay Coil Malfunction OKorNot Run OKorNot Run
Control - Relay Coil Malfunction OKorNot Run OKorNot Run
Ignition On/Start Circuit Source Bypass Relay Control Circuit Open Test Status

Circuit Short to Ground Open Short to Voltage
Operating Conditions:  Ignition=On
Parameter Normal Range:  OKorNot Run
B+ - Relay Coil OKorNot Run Malfunction OKorNot Run
Control - Relay Coil OKorNot Run Malfunction OKorNot Run
scientia non olet · About LEMON Manuals