LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Engine Controls And Fuel - 5.3L (L83) Or 6.2L (L86) - DTC P0443 To DTC P3452 And Diagnostic Information And Procedures) >> Diagnostic Information And Procedures >> DTC P0443, P0458 Or P0459: Evaporative Emission (EVAP) Purge Solenoid Valve Control Circuit >> Component Testing >> Dynamic Test

Dynamic Test

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the Q12 Evaporative Emission Purge Solenoid Valve.
  2. Install a 3 A fused jumper wire between the ignition terminal B or 1 and 12 V. Install a jumper wire between the control terminal A or 2 and ground.
  3. Verify the Evaporative Emission Purge Solenoid Valve turns on & off/clicks and flows vacuum.
    • If it does not turn on & off/click or flow vacuum. 

      Replace the Q12 Evaporative Emission Purge Solenoid Valve.

    • Go to next step: If it does turn on & off/clicks and flows vacuum. 
  4. All OK.
scientia non olet · About LEMON Manuals