LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Engine Controls And Fuel - 5.3L (L83) Or 6.2L (L86) - DTC P0443 To DTC P3452 And Diagnostic Information And Procedures) >> Diagnostic Information And Procedures >> Alcohol/Contaminants-In-Fuel Diagnosis >> Circuit/System Testing >> Particulate Contaminants in Fuel

Particulate Contaminants in Fuel

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using an approved fuel container, draw approximately 0.5 liter (0.53 qt) of fuel from the bottom of the fuel tank.
  2. Place the container on a level surface for approximately 5 min in order to allow settling of the particulate contamination. Particulate contamination will show up in various shapes and colors. Sand will typically be identified by a white or light brown crystals. Rubber will appear as black and irregular particles.
  3. Verify there are no physical contaminants or water present in the fuel sample.
    • If any physical contaminants or water are present 

      Clean the fuel system.

    • Go to next step: If no physical contaminants or water are present 
  4. All OK.
scientia non olet · About LEMON Manuals