LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Mechanical - 5.3L (L83) Or 6.2L (L86) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Vacuum Pump Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Universal Stretchy Belt Installer
    GM4622965Courtesy of GENERAL MOTORS COMPANY
  1. Install EN-51767-2  Universal Stretchy Belt Installer (1) onto the vacuum pump pulley.
    2. Fig 2: Installing Belt
    GM4622968Courtesy of GENERAL MOTORS COMPANY
  2. Position the belt (2) on the crankshaft and the vacuum pump pulleys as shown.
  3. Slowly rotate the crankshaft and vacuum pump pulleys in a clockwise direction until the belt (2) fully seats on both pulleys.
  4. Remove EN-51767-2  Universal Stretchy Belt Installer (1) from the vacuum pump pulley.
  5. Inspect the belt for proper installation and alignment.
  6. Rotate the balancer an additional 360 degrees to ensure proper belt installation.
  7. Install Steering Gear Skid Shield -Steering Gear Skid Shield Replacement
  8. Install Air Conditioning Compressor Belt - Air Conditioning Compressor Belt Replacement 
scientia non olet · About LEMON Manuals