Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the seal for proper orientation.
- Install the crankshaft front oil seal (3) onto the threaded rod, nut and washer from J-41478-A crankshaft front oil seal installer (1) and EN-51091 crankshaft front oil seal installer (2).
- Install the J-41478-A crankshaft front oil seal installer threaded rod, nut and washer (1) and EN-51091 crankshaft front oil seal installer (2) and oil seal (3), into the end of the crankshaft.
- Use the J-41478-A
crankshaft front oil seal installer (1) and EN-51091
crankshaft front oil seal installer (2) in order to install the oil seal (3) into the cover bore.
- Use a wrench and hold the hex on the installer bolt.
- Use a second wrench and rotate the installer nut clockwise until the seal bottoms in the cover bore.
- Remove the tool.
- Inspect the oil seal for proper installation. The oil seal should be installed evenly and completely into the front cover bore.
- Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
IMPORTANT:
For proper orientation, note the installation direction of the oil seal. The oil seal is a reverse-lip design. Install with "THIS SIDE OUT" displayed as shown.