LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Mechanical - 5.3L (L83) Or 6.2L (L86) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Air Conditioning Compressor Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Universal Stretchy Belt Installer
    GM4604055Courtesy of GENERAL MOTORS COMPANY
  1. Install EN-51767-1  Universal Stretchy Belt Installer (1) onto the balancer.
    2. Fig 2: Installing A/C Belt
    GM4604058Courtesy of GENERAL MOTORS COMPANY
  2. Position the belt (1) on the A/C pulley and the balancer as shown.
  3. Slide the belt installation tool downward, positioning the belt onto the A/C pulley, applying light tension to the belt.
  4. Slowly rotate the crankshaft and compressor pulleys in a counterclockwise direction until the belt (1) fully seats on both pulleys.
  5. Inspect the belt for proper installation and alignment.
  6. Rotate the balancer an additional 360 degrees to ensure proper belt installation.
  7. Install Steering Gear Skid Shield -Steering Gear Skid Shield Replacement
  8. Install Drive Belt - Drive Belt Replacement - Accessory 
scientia non olet · About LEMON Manuals