LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Engine Mechanical - 5.3L (L83) Or 6.2L (L86) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Automatic Transmission Flex Plate Removal

Automatic Transmission Flex Plate Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Flex Plate Bolts
    GM2966582Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The flex plate does not use a locating pin for alignment and will not initially seat against the crankshaft flange, but will be pulled onto the crankshaft by the engine flex plate bolts. This procedure requires a 3 stage tightening process.

  1. Mark or scribe the end of the crankshaft and the flex plate before removal.
  2. Remove the engine flex plate bolts (2).
  3. Remove the flex plate (1).
scientia non olet · About LEMON Manuals