Control Valve Body Assembly Installation

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Cadillac Escalade ESV, and 2018 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Control Valve Body Assembly

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Control Valve Body Assembly NOTE: Ensure the Automatic Transmission Fluid Pump Seal-Valve Body is in the Control Valve Body Assembly. Procedure NOTE: Ensure the wiring harness is not pinched anywhere after valve body installation. Install the control valve body assembly into the case. The locating pins on the bottom of the Control Valve Body Assembly will hold the Control Valve Body Assembly in place while installing bolts. Connect the main control wiring harness connector as shown.

Callout

Component Name

Control Valve Body Assembly

NOTE:

Ensure the Automatic Transmission Fluid Pump Seal-Valve Body is in the Control Valve Body Assembly.

Procedure

NOTE:

Ensure the wiring harness is not pinched anywhere after valve body installation.

Install the control valve body assembly into the case. The locating pins on the bottom of the Control Valve Body Assembly will hold the Control Valve Body Assembly in place while installing bolts.
Connect the main control wiring harness connector as shown.