Conditions for Running the DTC
WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Cadillac Escalade ESV, and 2018 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
P0711 Condition 1
- DTC P0712, P0713, P2818 = Not set
- DTCs related to the following system/component = Not Set
- B14A Transmission Output Shaft Speed Sensor / B115 Vehicle Speed Sensor
- B26 Crankshaft Position Sensor
- B34 Engine Coolant Temperature Sensor
- B74 Manifold Absolute Pressure Sensor
- B75 Mass Air Flow Sensor
- B107 Accelerator Pedal Position Sensor
- Q17 Fuel Injector
- Engine Misfire
- Fuel Trim System
- Accelerator Pedal Position Sensor = Greater than 4%
- Battery Voltage = Greater than 9 V
- Engine Coolant Temperature = -40 to 150°C (-40 to 302°F)
- Engine Speed = Greater than 500 RPM
- Engine Torque = Greater than 50 N.m (37 lb ft)
- Ignition = On
- Ignition Voltage = Greater than 9 V
- Transmission Fluid Temperature = -40 to 150°C (-40 to 302°F)
- Vehicle Speed = Greater than 10 km/h (7 MPH)
Frequency the DTC runs = Continuously - After the running conditions are met
P0711 Condition 2, 3 & P0712, P0713
- Battery Voltage = Greater than 9 V
- Ignition = On
- Ignition Voltage = Greater than 9 V
- {P0711 Condition 3} Transmission Fluid Temperature = -40 to 150°C (-40 to 302°F)
Frequency the DTC runs = Continuously - After the running conditions are met