LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Automatic Transmission - 10L80 (MF6) - Diagnostic Information And Procedures) >> Diagnostic Information And Procedures >> DTC P0711, P0712, P0713: Transmission Fluid Temperature Sensor >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Cadillac Escalade ESV, and 2018 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Remove the component: Automatic Transmission Fluid Pan
  3. Remove the component: Control Valve Assembly
  4. Disconnect the electrical connector: B13 Transmission Fluid Temperature Sensor
  5. Test for 20 to 200, 000 Ω between the test points: Signal terminal 2 & Low Reference terminal 1
    • If not between 20 and 200, 000 Ω 

      Replace the component: B13 Transmission Fluid Temperature Sensor

    • If between 20 and 200, 000 Ω 
  6. Verify the value is within the range listed in the table:
    • If not in the specified range 

      Replace the component: B13 Transmission Fluid Temperature Sensor

    • If in the specified range 
  7. All OK.
scientia non olet · About LEMON Manuals