Conditions for Running the DTC
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P010B, P012B, P012C, P012D, P0101, P0102, P0103, P0106, P0107, P0108, P0111, P0112, P0113, P0114, P0116, P0117, P0118, P0119, P0121, P0122, P0123, P0128, P012B, P012C, P012D, P0222, P0223, P0236, P0237, P0238, P0443, P0446, P0449, P0452, P0453, P0455, P0458, P0459, P0461, P0462, P0463, P0496, P0498, P0499, P0502, P0503, P0722, P0723, P111E, P117D, P017C, P017D, P017B, P117B, P117F, P117E, P117C, P2066, P2067, P2068, P1221, P222B, P222C, P222D, P222E, P262B, are not set.
- The barometric pressure (BARO) is greater than 70 kPa.
- The fuel level is between 10 - 90%.
- The cold start-up engine coolant temperature (ECT) and the start-up intake air temperature (IAT) are within 8°C (14°F).
- The engine coolant temperature (ECT) is greater than 63°C (145°F).
- The engine run time before engine shut-off was greater than 10 min.
- The drive distance before engine shut-off was greater than 8 km (5 miles).
- The ambient air temperature at the end of the drive cycle is between 0 - 34°C (32 - 93°F).
- DTC P0442 runs once per drive cycle during the hot soak period after the ignition is turned OFF and may require up to 40 min to complete. The control module will not make more than 2 test attempts per day. The time since the last completed engine off natural vacuum test must be at least 17 h if passed or 10 h if failed.