LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Controls And Fuel - 5.3L (L83) Or 6.2L (L86) - DTC P0010 To DTC P0442) >> Diagnostic Information And Procedures >> DTC P0420 Or P0430: Catalyst System Low Efficiency Bank 1 And 2 >> Repair Verification

Repair Verification

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install any components that have been removed or replaced during diagnosis.
  2. Perform any adjustments, programming or setup procedures that are required when a component is removed or replaced.
  3. Clear the DTCs with a scan tool.
  4. Turn OFF the ignition for 60 s
  5. Operate the vehicle within the Conditions for Running the DTC.
  6. Verify the scan tool Catalyst Monitor Not At Idle Test Conditions Met parameter changes to Yes.
    • If Yes is not displayed 

      Refer to step 5.

    • Go to next step : If Yes is displayed 
  7. Monitor the scan tool Catalyst Monitor Test State parameter. When the parameter indicates Active, the Catalyst Monitor Test is running.
  8. Continue to monitor the parameter. When the parameter indicates Inactive, the Catalyst Monitor Test has completed.
    NOTE: When the test has completed, the Catalyst Monitor Test Counter Bank 1 and Bank 2 parameters will increment by one and the Catalyst Monitor Test Result Bank 1 and Bank 2 parameters will indicate Passed, Failed or No Result.
    • If the Catalyst Monitor Test Result Bank 1 or Bank 2 parameter indicates No Result 

      Repeat steps 5 - 8 until the Test Result parameters indicate Passed or Failed

    • If the Catalyst Monitor Test Result Bank 1 or Bank 2 parameter indicates Failed 

      Refer to Circuit /System Testing below

    • Go to next step : If the Catalyst Monitor Test Result Bank 1 and Bank 2 parameters indicate Passed 
  9. All OK.
scientia non olet · About LEMON Manuals