Circuit/System Verification
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON.
- Verify there are no other DTCs set.
- If a DTC is set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step : If a DTC is not set
- If a DTC is set
- Operate the vehicle within the Conditions for Running the DTC.
- Verify the scan tool Catalyst Monitor Not At Idle Test Conditions Met parameter changes to Yes.
- If Yes is not displayed
Refer to step 3.
- Go to next step : If Yes is displayed
- If Yes is not displayed
- Monitor the scan tool Catalyst Monitor Test State parameter. When the parameter indicates Active, the Catalyst Monitor Test is running.
- Continue to monitor the parameter. When the parameter indicates Inactive, the Catalyst Monitor Test has completed.NOTE: When the test has completed, the Catalyst Monitor Test Counter Bank 1 and Bank 2 parameters will increment by one and the Catalyst Monitor Test Result Bank 1 and Bank 2 parameters will indicate Passed, Failed or No Result.
- If the Catalyst Monitor Test Result Bank 1 or Bank 2 parameter indicates No Result
Repeat steps 3 - 6 until the Test Result parameters indicate Passed or Failed
- If the Catalyst Monitor Test Result Bank 1 or Bank 2 parameter indicates Failed
Refer to Circuit/System Testing below
- Go to next step : If the Catalyst Monitor Test Result Bank 1 and Bank 2 parameters indicate Passed
- If the Catalyst Monitor Test Result Bank 1 or Bank 2 parameter indicates No Result
- All OK.