LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Controls And Fuel - 5.3L (L83) Or 6.2L (L86) - DTC P0010 To DTC P0442) >> Diagnostic Information And Procedures >> DTC P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308: Misfire Detected >> Circuit/System Description

Circuit/System Description

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.

For an overview of the component/system, refer to :

A misfiring cylinder causes slight variations in the rotational speed of the crankshaft. The ECM is able to detect these variations by closely monitoring the crankshaft position sensor signal. The signals of the camshaft position sensors are used to determine which cylinder is misfiring. If the ECM detects a misfire rate sufficient to cause emission levels to exceed mandated standards, DTC P0300 sets. Under certain driving conditions, a misfire rate can be high enough to cause the catalytic converter to overheat, possibly damaging the converter. The malfunction indicator lamp (MIL) flashes when converter overheating, damaging conditions are present and DTC P0300 is set.

scientia non olet · About LEMON Manuals