Conditions for Setting the DTC
P0030, P0036, P0050 or P0056
The engine control module detects an open circuit in the heater output low side driver circuit of the heated oxygen sensor when the heater is commanded OFF for greater than 5 s.
P0031, P0037, P0051 or P0057
The engine control module detects a short to ground in the heater output low side driver circuit of the heated oxygen sensor when the heater is commanded OFF for greater than 5 s.
P0032, P0038, P0052 or P0058
The engine control module detects a short to voltage in the heater output low side driver circuit of the heated oxygen sensor when the heater is commanded ON for greater than 5 s.
P0053, P0054, P0059 or P0060
The engine control module detects the HO2S heater is not within a specified resistance range at engine start-up.
P0135 or P0155
The engine control module detects that the HO2S 1 heater current is greater than 3.1 amps or less than 0.3 amps for greater than 8 s.
P0141 or P0161
The engine control module detects that the HO2S 2 heater current is greater than 2.9 amps or less than 0.3 amps for greater than 8 s.