Circuit/System Verification
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON. Engine Running.
- Verify the parameters listed below do not display Malfunction when commanding the HO2S Heater Bank 1 or 2 Sensor 1 or 2 to 0% and 100% with a scan tool :
- HO2S Heater Control Circuit Low Voltage Test Status Bank 1 or 2 Sensor 1 or 2
- HO2S Heater Control Circuit Open Test Status Bank 1 or 2 Sensor 1 or 2
- HO2S Heater Control Circuit High Voltage Test Status Bank 1 or 2 Sensor 1 or 2
- If Malfunction is displayed
Refer to Circuit/System Testing below.
- Go to next step : If Malfunction is not displayed
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing below.
- Go to next step : If the DTC does not set
- If the DTC sets
- All OK.