Conditions for Running the DTC

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.

P0010, P2088, P2089

Ignition Voltage = Greater than 11 V
Ignition Switch Position = Run/Crank
Camshaft Position Actuator Solenoid Valve = On

Frequency the DTC runs = Continuously - After the running conditions are met

P0011

DTC P0010, P0016, P0335, P0336, P0340, P0341 = Not set
Ignition Voltage = Greater than 11 V
Engine = Running
Desired Camshaft Position = Does not vary greater than 7.5° - For greater than 2 s
Camshaft Position Actuator = Enabled
Power Take-Off Switch = Off - If equipped

Frequency the DTC runs = Continuously - After the running conditions are met