LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Controls And Fuel - 5.3L (L83) Or 6.2L (L86) - DTC P0010 To DTC P0442) >> Diagnostic Information And Procedures >> DTC P0010, P0011, P2088 Or P2089: Camshaft Position Actuator Solenoid Valve >> Component Testing >> Dynamic Test

Dynamic Test

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/Vehicle - Off
  2. Disconnect the appropriate electrical connector : Q6 Camshaft Position Actuator Solenoid Valve
  3. Connect a jumper wire between the test points : Low Reference terminal 1/A & Ground
  4. Momentarily connect a 7.5 A fused jumper wire between the test points : Control terminal 2/B & B+

    Verify the component turns On and Off when connecting and disconnecting the jumper wire : Q6 Camshaft Position Actuator Solenoid Valve

    • If the component does not turn On and Off 

      Replace the component : Q6 Camshaft Position Actuator Solenoid Valve

    • Go to next step : If the component turns On and Off 
  5. All OK.
scientia non olet · About LEMON Manuals