Installation Procedure
WARNING: This page is about a different car, the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Cadillac Escalade ESV, and 2018 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the park pawl actuator rod (1) to the automatic transmission manual shift shaft position switch (2).
- Install the automatic transmission manual shift shaft position switch (2) to the transmission.
- Install the manual shift shaft (2) aligning the position switch assembly onto the shaft.
- Install the NEW manual shift shaft pin (1).
- Install the control valve body. Control Valve Body Replacement
- Install the shift cable and range selector cable lever (2) and cable as an assembly to the transmission. Automatic Transmission Range Selector Lever Cable Replacement
- Install the automatic transmission range selector lever nut (1). Automatic Transmission Range Selector Lever Cable Replacement
- Fill the transmission. Transmission Fluid Fill Procedure