LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Antilock Brake System) >> Repair Instructions >> Rear Wheel Speed Sensor Ring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (6-Lug Wheel)Tire and Wheel Removal and Installation (8-Lug Wheel) .
  3. Remove the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement .
  4. Remove the rear axle shaft bearing. Refer to Rear Axle Shaft Bearing Replacement .
  5. Remove the rear wheel speed sensor ring from the axle housing using the J-45857  tone wheel and/or bearing remover (1) and the J-2619-01  slide hammer (2).
    Fig 1: Removing Wheel Speed Sensor Ring From Axle Housing
    GM889095Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About LEMON Manuals