LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Antilock Brake System) >> Repair Instructions >> Rear Wheel Speed Sensor Ring Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear wheel speed sensor ring using the J-45860  tone ring installer (1) and the J-8092  driver handle (2).
    Fig 1: Installing Wheel Speed Sensor Ring
    GM885621Courtesy of GENERAL MOTORS COMPANY
  2. Drive the wheel speed sensor ring into the axle housing until the tool bottoms against the tube.
  3. Install the rear axle shaft bearing. Refer to Rear Axle Shaft Bearing Replacement .
  4. Install the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement .
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (6-Lug Wheel)Tire and Wheel Removal and Installation (8-Lug Wheel) .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals