Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.

Place the ignition switch in the OFF position.
Remove the brake pressure modulator valve (BPMV) assembly. Refer to Brake Pressure Modulator Valve Replacement .
Remove the BPMV bolt (1).

Fig 1: BPMV Bolt
Courtesy of GENERAL MOTORS COMPANY
Carefully separate the BPMV assembly from the BPMV bracket insulators and remove the BPMV bracket (1).

Fig 2: BPMV Bracket
Courtesy of GENERAL MOTORS COMPANY

NOTE: Do not pry on the accumulator caps on the underside of the BPMV.
Inspect the insulators for damage and replace, if necessary.