LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Antilock Brake System) >> Diagnostic Information And Procedures >> DTC C0131: Traction Control System Pressure Circuit >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Yukon XL, 2018 GMC Yukon, 2018 Chevrolet Tahoe, 2018 Chevrolet Suburban, and 2018 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Apply and release brake pedal. Verify the brake stop lamps operate properly.
    • Go to next step: If the brake stop lamps operate properly 
  3. Verify that DTC C0131 is not set.
    • If the DTC is set 
    1. Perform the Brake Pressure Modulator Valve Pressure Sensor Calibration .
    2. Verify the DTC does not set.
      • If the DTC sets, replace the K17 Electronic Brake Control Module with the Brake Pressure Modulator.
      • Go to next step: If the DTC does not set
    3. All OK.
    • Go to next step: If the DTC is not set 
  4. All OK.
scientia non olet · About LEMON Manuals