Driver Or Passenger Seat Cushion Frame Replacement (Passenger Side With 6-way Power)

Fig 1: Driver or Passenger Seat Cushion Frame (Power)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Front Seat Cushion Cover and Pad Replacement
1	Driver or Passenger Seat Back Frame Fastener [4x] CAUTION: Refer to Fastener Caution . Procedure Remove the front seat recliner control bracket. Clean the thread locking compound from the bolts and reapply new thread locker. The bolts are held in by Blue 242® medium strength loctite. Tighten 50 N.m (37 lb ft)
2	Front Seat Adjuster Front Spacer NOTE: Installed on the outboard side only.
3	Front Seat Adjuster Stop [2x] NOTE: When replacing the seat cushion frame, ensure the front seat adjuster stops are installed. The frame may need to be adjusted to access the stops.
4	Driver or Passenger Seat Cushion Frame Procedure Disconnect the electrical connector. Transfer components as necessary.