Electronic Suspension Rear Position Sensor Replacement - Left Side

Fig 1: Electronic Suspension Rear Position Sensor - Left Side

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Remove the left rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (6-Lug Wheel)Tire and Wheel Removal and Installation (8-Lug Wheel)
1	Electrical Connector
2	Position Sensor Servo Arm Bracket Bolt CAUTION: Fastener Caution Tighten 17 N.m (13 lb ft)
3	Position Sensor Bracket Bolt Tighten 12 N.m (106 lb in)
4	Electronic Suspension Position Sensor Procedure Perform the Suspension Position Sensor Trim Height Calibration. Refer to Electronic Suspension Position Sensor Trim Height Calibration