LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LS >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Repair Instructions >> Steering Wheel Airbag Replacement (Cadillac)

Steering Wheel Airbag Replacement (Cadillac)

Fig 1: Steering Wheel Airbag (Cadillac)
GM3273246Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
WARNING: Refer to SIR Inflator Module Handling and Storage Warning .
WARNING: Refer to SIR Warning .
Preliminary Procedure Disable the SIR system. Refer to SIR Disabling and Enabling .
1 Steering Wheel Inflatable Restraint Module
WARNING: After installation of the steering wheel airbag module to the steering wheel, slightly pull the module outward. If there is no give on the airbag module then it is secured correctly. If the airbag module is not fully attached personal injury could result.

Procedure

  1. Rotate steering wheel counter clockwise to line up lower left hand spoke with the ignition key or lower right hand spoke with turn signal.
  2. Fully insert a small screwdriver or equivalent tool at a slight angle into access holes on the right and left side of the steering wheel.
  3. Apply and keep constant pressure on handle towards column shroud to push the spring fastener inward to release the steering wheel airbag from the steering wheel.
  4. Release the connector position assurance (CPA) retainer.
  5. Disconnect the electrical connectors.
  6. Refer to Inflatable Restraint Module Handling and Scrapping .
scientia non olet · About LEMON Manuals