LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - JATCO CVT) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Set the park brake and chock the wheels.
  2. Without draining the coolant or removing the hoses, remove and position aside the radiator surge tank. Refer to Radiator Surge Tank Replacement .
  3. Remove the ECM from the battery tray. Refer to Engine Control Module Replacement .
  4. GM4112708Courtesy of GENERAL MOTORS COMPANY

    Position the transmission manual shift lever into the park position.

  5. Disconnect the transmission range selector lever cable terminal (1) from the transmission range selector lever.
  6. Press the retainer clip tabs inward in order to release the transmission range selector lever cable (2) from the cable bracket.
  7. GM4112720Courtesy of GENERAL MOTORS COMPANY

    Remove the transmission range selector lever cable clip nuts (1).

  8. Remove the transmission range selector lever cable bracket (2) from the underbody.
  9. Remove the front floor console. Refer to Front Floor Console Replacement .
  10. GM4112721Courtesy of GENERAL MOTORS COMPANY

    Disconnect the transmission range selector lever cable terminal (2) from the shift lever pin (3).

  11. Release the transmission range selector lever cable retainer (1) and remove the transmission range selector cable from the transmission control lever base (4).
  12. GM4112723Courtesy of GENERAL MOTORS COMPANY

    Remove the transmission range selector lever cable grommet nuts (1).

  13. Remove the transmission range selector lever cable grommet (2).
  14. Remove the transmission range selector lever cable from the vehicle.