LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - JATCO CVT) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Set the park brake and chock the wheels.
  2. Without draining the coolant or removing the hoses, remove and position aside the radiator surge tank. Refer to Radiator Surge Tank Replacement .
  3. Remove the ECM from the battery tray. Refer to Engine Control Module Replacement .
  4. GM4204275Courtesy of GENERAL MOTORS COMPANY

    Remove the battery positive cable retainer (1) from the range selector lever cable bracket.

  5. GM4112708Courtesy of GENERAL MOTORS COMPANY

    Disconnect the transmission range selector lever cable terminal (1) from the transmission range selector lever.

  6. Disconnect the range selector lever cable (2) from the range selector lever cable bracket.
  7. GM4112716Courtesy of GENERAL MOTORS COMPANY

    Remove the transmission range selector cable bracket bolts (1).

  8. Remove the transmission range selector cable bracket (2).