Output Speed Sensor Replacement
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| Preliminary Procedure Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection . |
|
| 1 | Output Speed Sensor Bolt
CAUTION:
Refer to Fastener Caution . Tighten 6 N.m (53 lb in) |
| 2 | Output Speed Sensor Procedure Disconnect the output speed sensor electrical connector. |
| 3 | Output Speed Sensor O-Ring Seal
NOTE:
Do not reuse the output speed sensor O-ring seal. |