Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Install the NEW O-ring (1) to the terminal assembly.
Courtesy of GENERAL MOTORS COMPANY

Connect the terminal assembly connector and Install the terminal assembly (1) to the control valve body.
Courtesy of GENERAL MOTORS COMPANY

Check that the terminal assembly wiring (1) is not entangled with the terminal assembly bracket (2).
Install the control valve body to the transmission.
Fig 1: Identifying Control Valve Body Mounting Bolts
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Install the 11 control valve body mounting bolts (1) and tighten to 8 N.m (71 lb in)
Courtesy of GENERAL MOTORS COMPANY

If equipped with start/stop system, install the NEW O-ring (2) to the sub strainer (3).
If equipped with start/stop system, install the sub strainer (3) to the control valve body.
Install the sub strainer bolt (1) and tighten to 8 N.m (71 lb in).
Courtesy of GENERAL MOTORS COMPANY
NOTE:
- To prevent excessive torque application to the manual shaft, tighten nut by fixing the manual plate with a flat-blade screwdriver or an equivalent.
- To prevent deformation to manual valve, never allow the tool (e.g. screwdriver) to directly touch the manual valve.
Install the manual plate (1) and the spring washer (2) to the manual shaft.
Install the manual plate mounting nut (3) and tighten to 22 N.m (16 lb ft).
Courtesy of GENERAL MOTORS COMPANY

Install the NEW O-ring (1) to the fluid strainer.
Courtesy of GENERAL MOTORS COMPANY

Install the fluid strainer (2) to the control valve body.
Install the 3 fluid strainer mounting bolts (1) and tighten to 8 N.m (71 lb in).
Install the control valve body cover. Refer to Control Valve Body Cover Replacement .
Courtesy of GENERAL MOTORS COMPANY

Align the marking (1) on the transmission harness connector terminal with the marking (2) on bayonet ring (3) to insert the connector.
Courtesy of GENERAL MOTORS COMPANY
NOTE:
- Securely align the marking on the harness connector terminal body with the bayonet ring slit. Then, be careful not to make a half fit condition.
- Never mistake the slit of the bayonet ring for other dent portion.
Rotate the bayonet ring (3) clockwise until the marking (1) on the transmission harness connector terminal body is aligned with the slit (2) on bayonet ring.
Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
Fill the transmission fluid. Refer to Transmission Fluid Drain and Fill (Maintenance) Transmission Fluid Drain and Fill (Repair) .
Perform the transmission service fast learn procedure. Refer to Transmission Service Fast Learn Procedure (MR8) .