At Idle Engine Speed
WARNING: This page is about a different variant/trim than selected.
- Check the engine oil level. Refill if necessary.
- With the engine warmed up, drive the vehicle.
- Check the CVT fluid level and condition. Refill if necessary. Refer to Transmission Fluid Level and Condition Check .
- Block the front and rear wheels and apply the parking brake fully.
- Start the engine and set A/C OFF.
- Set the scan tool.
- Select "Line Pressure" in data menu.
- Measure the line pressure at idle speed.
NOTE:
When ambient temperature is 20°C (68°F), it takes about 10 minutes for the CVT fluid to warm up to 50 - 80°C (122 - 176°F).
NOTE:
Keep the brake pedal pressed all the way down during the measurement.
Line Pressure Test Result
| Selector Lever Position | Engine Speed | Line Pressure |
|---|---|---|
| P and N Range | At Idle | 275 - 870 kPa (39.9 - 126.2 psi): 1.0 Engine 400 - 1020 kPa (58.0 - 147.9 psi): 1.4 Engine |
| R and D Range | At Idle |