Circuit/System Description

WARNING: This page is about a different variant/trim than selected.

For an overview of the component/system, refer to: Electronic Component Description

Circuit	Description
Ignition	Supplied from a relay.
Signal	Regulated voltage supplied by the control module.
Signal	The control module input circuit has an internal resistance connected to ground.
Ground	Ground connection G110

Component	Description
G5 Transmission Fluid Pump - Electric/Auxiliary	An electric motor used to maintain transmission fluid pressure when the engine turns off during the stop mode of stop/start operation
Transmission Fluid Pump Relay	A relay is a switch that is actuated by a solenoid.
K71 Transmission Control Module	The control module receives information from a variety of sensors, switches and serial data information from other control modules. This information is used to control a combination of solenoid valves to obtain the correct line pressure, gear ratio and torque converter clutch operation.