LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - JATCO CVT) >> Diagnostic Information and Procedures >> DTC P1790 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    If the TCM is not completely shut down, this procedure may not complete properly. It may also be necessary to physically disconnect the scan tool from the vehicle to ensure complete power down.

  1. Ignition OFF for at least one minute to allow for the complete shutdown of the K71 Transmission Control Module.
  2. Ignition ON.
  3. Using the scan tool, perform the Transmission Adaptive Pressure Reset. Refer to: Transmission Service Fast Learn Procedure (MR8) 
  4. Clear the DTCs.
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data. The DTC should not set.

    Verify DTC P1790 is not set.

    • Test failed 1 time(s) If the DTC sets 

      Refer to: Step 1

    • Test failed 2 time(s) If the DTC sets 

      Replace the component: Q8 Control Solenoid Valve Assembly

    • Go to next step: If the DTC does not set 
  6. All OK.
scientia non olet · About LEMON Manuals