Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - On
- Verify the scan tool parameter: Ignition Voltage = Greater than 8.4 V
- If not the specified value
Refer to: Circuit/System Testing
- Go to next step: If the specified value
- If not the specified value
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify DTC P0855 is not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.