Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

Condition 1

TCM DTC P0705, P0706, P0796, P0797, P0961, P0962, P0963, P2714, or P2715 is not set.
System Voltage = 9-32 V
Transmission Range P, N or R.
High clutch pressure command 0 kPa (0 PSI)
ROM assembly not communicating.
DTC P0871 runs continuously.

Condition 2

TCM DTC P0705, P0706, P0796, P0797, P0961, P0962, P0963, P2714, or P2715 is not set.
System Voltage = 9-32 V
Transmission Range D or L.
High clutch pressure command 0 kPa (0 PSI)
Engine Speed greater than 400 RPM.
Vehicle Speed less than 10 km/h (7 mph).
Current commanded auxiliary gear 1st gear.
ROM assembly not communicating.
DTC P0871 runs continuously.

Condition 3

TCM DTC P0705, P0706, P0796, P0797, P0961, P0962, P0963, P2714, or P2715 is not set.
System Voltage = 9-32 V
Transmission Range D or L.
High clutch pressure command greater than 200 kPa (29 PSI).
Engine Speed greater than 550 RPM.
Output gear speed greater than 300 RPM.
Secondary pulley speed greater than 300 RPM.
Throttle position sensor greater than 7.8%.
Current commanded auxiliary gear 2nd gear.
Actual auxiliary gear ratio less than 1.1.
Vehicle Speed less than 10 km/h (7 mph).
ROM assembly not communicating.
DTC P0871 runs continuously.