Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Verify the scan tool parameter: Line Pressure = 0.09 to 4.7 V
- If not between 0.09 and 4.7 V
  Refer to: Circuit/System Testing
- Go to next step: If between 0.09 and 4.7 V
Verify the scan tool parameter: Line Pressure - Varies with changes in vehicle speed.
- If Line Pressure does NOT vary with vehicle speed
  Refer to: Circuit/System Testing
- Go to next step: If Line Pressure does vary with vehicle speed
Verify DTC P0841, P0842 or P0843 is only set as a history DTC.
- If any of the DTCs are set as current
  Refer to: Circuit/System Testing
- Go to next step: If any of the DTCs are only set as history
  Go to next step: Refer to: Testing for Intermittent Conditions and Poor Connections
Clear DTC P0841, P0842 or P0843 from history.
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- If any of the DTCs are set
  Refer to: Circuit/System Testing
- Go to next step: If none of the DTCs set
All OK.