LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - JATCO CVT) >> Diagnostic Information and Procedures >> DTC P0741, P0742, P0796, P0797, P2714, or P2715 (MR8) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. T12 Automatic Transmission Assembly = Verify fluid level and condition are correct.
  2. Verify DTC P0970, P0971, P2720, P2721, 2763, P2764 is not set.
    • Go to next step: If none of the DTCs are set 
  3. Clear DTC P0741, P0742, P0796, P0797, P2714, P2715
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  5. Verify the DTC does not set.
    • If any of the DTCs are set 

      Replace the component: Q8 Control Solenoid Valve Assembly

    • Go to next step: If none of the DTCs set 
  6. All OK.
scientia non olet · About LEMON Manuals