Conditions for Setting the DTC

Condition 1 (Low Speed)

• The transmission control module detects a low pulse signal from the output shaft speed sensor when there is a high pulse signal coming from the secondary pulley speed sensor for 5 ms.
• Transmission OSS parameter 250 RPM or less.
• Secondary pulley speed parameter is 1500 RPM or greater for 10 s.

Condition 2 (During Driving)

• The transmission control module detects no pulse signal from the output shaft speed sensor when there are pulses from the secondary speed sensor for 500 ms.
• Output shaft speed sensor parameter is 0 RPM for 500 ms.