Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Verify the correct fluid level: Transmission Fluid Level and Condition Check .
Verify that DTC P0111, P0112, P0113, P0114, P0117, P0118 or P0119 is not set.
- If DTC P0111, P0112, P0113, P0114, P0117, P0118 or P0119 is set
  Diagnose that DTC first. Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If DTC P0111, P0112, P0113, P0114, P0117, P0118 or P0119 is not set

NOTE:

During a road test, the transmission fluid temperature should steadily increase to a normal operating temperature, and then stabilize.

Verify the Transmission Fluid Temperature parameter increases greater than 2°C (3.5°F) after operating the vehicle at 64 km/h (40 mph) for 10 minutes.
- If the temperature does not increase greater than 2°C (3.5°F)
  Refer to: Circuit/System Testing
- Go to next step: If the temperature does increase greater than 2°C (3.5°F)
Verify that the transmission fluid temperature parameter is at or near the engine coolant temperature parameter.
- If the transmission fluid temperature parameter is NOT at or near the engine coolant temperature parameter
  Refer to: Circuit/System Testing
- Go to next step: If the transmission fluid temperature parameter IS at or near the engine coolant temperature parameter
Verify DTC P0711, P0712, or P0713 is only set as a history DTC.
- If any of the DTCs are set as current
  Refer to: Circuit/System Testing
- Go to next step: If any of the DTCs are only set as history
  Go to next step: Refer to: Testing for Intermittent Conditions and Poor Connections
Clear DTCs
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- If any of the DTCs are set
  Refer to: Circuit/System Testing
- Go to next step: If none of the DTCs are set
All OK.