LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transmission Cooling System) >> Repair Instructions >> Transmission Fluid Cooler Pipe Connector Replacement - Radiator >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Inspect the new O-ring seals for cracks, cuts or damage. Replace if necessary.
  2. GM1443001Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    NOTE:

    The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.

    Install the oil cooler fitting to the radiator and tighten to 20 N.m (15 lb ft).

  3. Install the transmission oil cooler pipes to the oil cooler fittings on the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  4. Fill the cooling system. Refer to Cooling System Draining and Filling .
  5. Adjust the transmission fluid level. Refer to Transmission Fluid Drain and Fill (Maintenance)Transmission Fluid Drain and Fill (Repair) .
  6. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals