Transmission Fluid Cooler Flow Test and Flushing: Clean-up
WARNING: This page is about a different variant/trim than selected.
- Turn the main function switch (2) to the IDLE position and allow the supply vessel pressure to dissipate.
- Turn the main power switch (1) to the OFF position.
- Disconnect the supply and waste hoses and the 12-volt power source from the vehicle.
Disconnect the air supply hose from DT-45096 flush and flow test tool.
- Dispose of the waste ATF in accordance with all applicable federal, state, and local requirements.
NOTE:
A small amount of water may drain from the bottom of the unit when the air supply is disconnected. This is a normal operation of the built-in water separator.