LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 1.0L (L5Q) Or 1.4L (LV7) - Repair Instructions - Off Vehicle >> Repair Instructions - Off Vehicle >> Intake Manifold Installation (L5Q)

Intake Manifold Installation (L5Q)

Fig 1: Identifying Intake Manifold Components And Bolts With Tightening Sequence (L5Q)
GM3973942Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Intake Manifold Gasket
NOTE:

Use a NEW gasket. Ensure the mating surfaces are clean and free of debris.
2 Intake Manifold
3 Intake Manifold Bolt [5x]
CAUTION:

Refer to Fastener Caution .

NOTE:

The ground cable for the fuel rail is captured by one of the intake manifold bolts. If equipped, the ground cable for the LPG fuel rail is also captured by one of the intake manifold bolts. Ensure all fuel rail ground cables are captured at the intake manifold bolts.


Procedure 
Tighten the bolts in sequence in two steps final torque.
Tighten 
10 N.m (89 lb in)
scientia non olet · About LEMON Manuals