LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission - Y4A/Y4M) >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4043910Courtesy of GENERAL MOTORS COMPANY

    Install the transmission mount strut (2) to the cradle.

    2. CAUTION:

    Refer to Fastener Caution .

    CAUTION:

    Refer to Torque-to-Yield Fastener Caution .

  2. Install the NEW transmission mount strut rear bolt (1) and tighten to 100 N.m (74 lb ft) + 60 to 75 degrees.
  3. GM4043909Courtesy of GENERAL MOTORS COMPANY

    Install the NEW transmission mount strut front bolt (1) and tighten to 100 N.m (74 lb ft) + 60 to 75 degrees.

  4. Remove the jack stand.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals