Clutch Pedal Position Learn

WARNING: This page is about a different variant/trim than selected.

NOTE:

The clutch pedal position (CPP) sensor learn procedure is required when the following service procedures have been performed regardless of whether DTC P080A is set:

An engine control module (ECM) replacement
A CPP sensor replacement
Any repairs which affect the CPP sensor relationship

Perform each step listed below:
- Set parking brake
- Block drive wheels

NOTE:

For vehicles equipped with the push button ignition switch, ensure the power mode is RUN.

Engine OFF, with the ignition ON.
Verify no other DTCs are set, except DTC P080A.
- If other DTCs are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If no other DTCs are set
Using a scan tool, select Clutch Pedal Position Sensor Learn.

NOTE:

The CPP sensor learn procedure cannot be performed more than once per ignition cycle.

Fully depress and hold the clutch pedal and select Continue.
Select Learn.
- If the scan tool CPP Learn Status is Unsuccessful - Sensor Detected Movement
  Verify vehicle is stopped with the parking brake set, and repeat the procedure.
- If the scan tool CPP Learn Status is Unsuccessful - Sensor Low Voltage or Unsuccessful - Sensor High Voltage
  Refer to DTC P0806-P0808 .
- If the scan tool CPP Learn Status is Not Learned
  Refer to DTC P080A .
- Go to next step: If the scan tool CPP Learn Status is Complete or Performed Successfully
Verify DTC P080A ran and passed this ignition cycle.
- If the scan tool indicates DTC P080A failed or did not run this ignition
  Refer to DTC P080A .
- Go to next step: If the scan tool indicates DTC P080A ran and passed this ignition cycle
Turn OFF the ignition for 30 seconds after the learn procedure has successfully completed in order to store the CPP sensor variation values in ECM history.