LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Horn System) >> Diagnostic Information and Procedures >> Horns Malfunction >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the scan tool parameter: Horn Switch=Inactive
    • If not the specified state 

      Refer to Circuit/System Testing - Test 1

    • If the specified state 
  2. Operate the component: S33 Horn Switch - Pressed

    Verify the scan tool parameter: Horn Switch=Active

    • If not the specified state 

      Refer to Circuit/System Testing - Test 1

    • If the specified state 
  3. Perform the scan tool control function: Horn Relay Command - On and Off

    Verify the component turns On and Off: P12 Horn & The horn should emit a clear and even tone.

    • If the component does not turn On and Off 

      Refer to Circuit/System Testing - Test 2

    • If an abnormal noise is present 
    • Refer to Circuit/System Testing - Test 3
    • If the component turns On and Off & If no abnormal noise is present 
  4. All OK.
scientia non olet · About LEMON Manuals