LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Drum Brake System) >> Repair Instructions >> Rear Brake Backing Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear brake backing plate (2) and the rear brake backing plate spacer (3) to the rear wheel bearing and hub assembly.
    Fig 1: Rear Wheel Bearing And Hub Assembly
    GM4002654Courtesy of GENERAL MOTORS COMPANY
  2. Install the rear wheel bearing and hub assembly (1) with rear brake backing plate and spacer to the rear axle. Refer to Rear Wheel Bearing and Hub Replacement .
  3. Install the wheel cylinder. Refer to Rear Brake Cylinder Replacement .
  4. Install the brake shoes. Refer to Brake Shoe Replacement .
  5. Install the park brake cable retaining clip (1) to the drum brake backing plate.
    Fig 2: Rear Park Brake Cable Retaining Clip
    GM4002648Courtesy of GENERAL MOTORS COMPANY
  6. Install the rear wheel speed sensor, if equipped. Refer to
  7. Adjust the drum brakes. Refer to Drum Brake Adjustment .
  8. Install the brake drum. Refer to Brake Drum Replacement .
  9. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual)Hydraulic Brake System Bleeding (Pressure) .
  10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals