Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Refer to Brake Dust Warning .

Raise and support the vehicle. Refer to Vehicle Lifting and Jacking Caution .
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Remove the brake drum. Refer to Brake Drum Replacement .
Remove the spring fastener (1) and upper brake shoe return spring (2).

Fig 1: Spring Fastener And Upper Brake Shoe Return Spring
Courtesy of GENERAL MOTORS COMPANY
Remove brake adjuster actuator lever spring (1).

Fig 2: Brake Adjuster Actuator Lever Spring
Courtesy of GENERAL MOTORS COMPANY
Remove the brake adjuster actuator lever (1).

Fig 3: Brake Adjuster Actuator Lever
Courtesy of GENERAL MOTORS COMPANY
Spread the top of the brake shoes apart slightly and remove the brake shoe adjuster (1).

Fig 4: Brake Shoe Adjuster
Courtesy of GENERAL MOTORS COMPANY
Remove the brake shoe hold down spring and cup assemblies (1) by compressing the spring and rotating the assembly 1/4 turn.

Fig 5: Remove Brake Shoe Hold Down Spring And Cup Assemblies By Compressing Spring
Courtesy of GENERAL MOTORS COMPANY
Remove the 2 hold-down spring and cup assembly pins (2).
Rotate the primary brake shoe (1) toward the wheel hub assembly and release the brake shoe from the lower brake shoe return spring.

Fig 6: Primary Brake Shoe
Courtesy of GENERAL MOTORS COMPANY
Remove the lower brake shoe return spring (1).

Fig 7: Lower Brake Shoe Return Spring
Courtesy of GENERAL MOTORS COMPANY
Inspect the drum brake hardware and replace any components, as necessary. Refer to Drum Brake Hardware Inspection .
Compress the park brake cable return spring and release the park brake cable fitting from the park brake apply lever and remove the brake shoe (1).

Fig 8: Brake Shoe
Courtesy of GENERAL MOTORS COMPANY