LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2018 >> Spark LT, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 91 (Rear Suspension System) >> Repair Instructions >> Rear Wheel Bearing and Hub Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the brake drum. Refer to Brake Drum Replacement .
  4. Remove the rear wheel speed sensors. Refer to Rear Wheel Speed Sensor Replacement .
  5. Remove the rear wheel hub to rear axle bolts (1).
    Fig 1: Rear Wheel Hub To Rear Axle Bolts
    GM4042037Courtesy of GENERAL MOTORS COMPANY
  6. Remove the rear wheel bearing and hub assembly (1) from the rear axle assembly.
    Fig 2: Rear Wheel Bearing And Hub Assembly
    GM4042038Courtesy of GENERAL MOTORS COMPANY
  7. Secure the rear brake backing plate and spacer with the rear wheel hub to rear axle bolts not to fall down.
scientia non olet · About LEMON Manuals