Measurement Definitions
WARNING: This page is about a different car, the 2017 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
P Height: The vertical distance from the ground to the top of the front wheel opening through the center line of the front wheel
R Height: The vertical distance from the ground to the top of the rear wheel opening through the center line of the rear wheel
Use the following procedures to measure the P and R dimensions:
- Push the front bumper down a minimum of 38 mm (1.59 in) and release. Perform this step three times.NOTE:
- Measure from the center of the wheel well opening to the ground.
- The left and right P and R height differences should be no more than 10 mm (0.39 in).
- Measure and record the trim height per the "Measurement Definitions" above.
- Lift the bumper up a minimum of 38 mm (1.59 in) and release. Perform this step three times.
- Measure and record the trim height per the "Measurement Definitions" above.
- The true P height measurement is the average of the measurements taken in step 2 and 4. Refer to Trim Height Specifications
- Repeat the above steps at the rear of the vehicle for the R heights.